Put rose pruning and planting on the calendar


February 5, 2016

RoseBy Kym Pokorny

Valentine’s Day is coming up and that means it’s time to pay attention to your loved ones and your roses, too.

On the west side of the Cascade Range, mid-February is generally time to start thinking about pruning, according to Amy Jo Detweiler, a horticulturist with Oregon State University’s Extension Service. In Central Oregon, April or May is the best time. In both cases, take your cue from the plants. When the buds begin to swell and get ready to break open, pull out your pruners.

Detweiler recommends using bypass pruners rather than anvil because they cut more like scissors and won’t crush the stems. Make sure they are sharp. Have some rubbing alcohol on hand to for dipping the blades in between cuts, especially as you move from rose to rose.

As you get started, stand back and survey the rose. First cut out any dead, diseased or damaged wood (also called canes). Remove anything smaller than a pencil. Then find three to five of the healthiest canes and clip those back uniformly to 14 to 16 inches above the ground. Make your cut just above a bud that faces outward and prune at a 45-degree slant.

“You want the shrub to grow outward so that the center remains relatively open,” Detweiler said. “That increases air circulation and reduces the chances of disease.”

Be sure to clean up and remove all debris.

Detweiler’s directions specifically apply to modern roses such as hybrid teas, floribundas and grandifloras, but also pertain to old-fashioned and shrub roses, though those can be pruned taller – just a third of the plant’s size. Roses that bloom just once a year should be pruned right after blooming.

In western Oregon, prime planting time is coming up, Detweiler said. However, it’s too early for Central Oregon, where gardeners should wait until the ground starts to thaw at the end of April into May. When you go to the garden center to buy a rose, look for a healthy plant with stems that are green and healthy. Dead branches or dieback might indicate disease. Also, make sure the roots aren’t winding around inside the pot or growing thickly out the bottom drainage holes.

Whether you live on the west or east side of the mountains, planting is the same, she said. Dig a generous hole, twice as wide as the pot the rose came in and as deep. Mix together one third organic amendment such as planting compost and two thirds native soil that came out of the hole.

Place plant in the hole and fill in with soil and compost mixture. In milder climates, make sure graft line is above ground. In colder climates, bury it 2 inches below ground. Water well. Mulch with 2 to 5 inches of organic mulch, such as bark chips or compost. Keep it level and even, not like a volcano.

Image above: A beautiful rose depends on appropriate annual pruning, which is easy with a little practice. Photo from Oregon State University’s Extension Service photo archive.


McKenzie River Reflections


Reader Comments(0)


Powered by ROAR Online Publication Software from Lions Light Corporation
© Copyright 2023